It is currently Thu Sep 21, 2017 7:30 pm

All times are UTC

Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: SofthEther with 2 NICS
PostPosted: Fri Sep 08, 2017 6:18 pm 

Joined: Fri Sep 08, 2017 6:00 pm
Posts: 1

I'm trying to setup softether on Windows Server 2008 R2 X64 to access my Internal LAN. My setup is:

1 server with 2 NIC's

NIC1 --> (connected to internet) NIC2 --> (connected to my LAN)

I have created two hubs:

HUB LAN --> It is locally bridged to the NIC 2, called "Intranet" on my windows server. This configuration was made on "Local Bridge Settings"

1. Created 1 user called test.
2. Secure NAT is Enable. In secure nat Configuration Virtual host interface hast the IP also DHCP is enable with the range from to

In Edit static routing table to push i have,

After that i HAVE created a Virtual Layer 3 Switch called "Router" with the following configuration:
1. Virtual interface mask attached to Virtual Hub "LAN"
2. Virtual interface mask attached to Virtual HUB "VPN"
3. In routing Table default route metric 1

But... the problem is that i can connect to the vpn and get an ip address from the pool but i can't access my local lan. There is no ping to any other IP address on network 10.167.7.X or and can't ping Layer 3 switch virtual interface

From my local network i can ping the virtual interface on my Virtual Layer 3 switch

Some can help me to make it work? Any ideas?

I didn't find information about this kind of setup


PD: Excuse my bad english please!

Reply with quote  
PostPosted: Tue Sep 12, 2017 7:13 pm 

Joined: Fri Jul 03, 2015 2:21 pm
Posts: 188
Hello there! Technically speaking, this statement: "" is a wrong statement. Most likely that network devices accept it but with a little change, which is modifying it as follows: "" >> "". So when you try to access your LAN from the remote side, your packets, actually, are destined toward your local router on the remote side because you don't have a routing entry for your LAN subnet, which is Let me know if you can change your mask then I would further help you solving your issue.

Reply with quote  
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group
Return to