TeamViewer incompatibility

Post your questions about SoftEther VPN software here. Please answer questions if you can afford.
Post Reply
Posts: 3
Joined: Wed Jul 18, 2018 10:02 am

TeamViewer incompatibility

Post by Unleavened » Thu Nov 01, 2018 9:02 am

Hello, everyone!
I have an issue, when it comes to connecting to a PC with TeamViewer. If the remote PC (that is the one I am trying to connect to) is connected to the SoftEther VPN server via the SoftEther Client, I can't access the remote PC with TeamViewer. If I disconnect the remote PC from the VPN, I can connect to it using TeamViewer, but if I then connect the remote PC to the VPN while the TeamViewer connection is active, the TeamViewer connection gets disconnected. I have searched for a solution, and I have came across this topic on your forums: viewtopic.php?t=5606 but this discusses the TeamViewer connection dropping when connect / reconnect to VPN. My issue is that I can't even connect to the remote PC via TeamViewer while the remote PC is connected to the VPN. Regardless of that, I have tried to increase the metric value of the card, as suggested in that topic, however I do not understand something about it. I have followed the tutorial at ... n-windows/ but after changing the metric value as explained on the site, the output of the "netstat -rn | more" command does not change. Even stranger than that, the numbers on the left side, the metric values are not the same as they are in the place where I change them.
I appreciate any help, thanks.

Posts: 2247
Joined: Mon Feb 24, 2014 11:03 am

Re: TeamViewer incompatibility

Post by thisjun » Thu Nov 15, 2018 7:58 am

What metric value did you change from to?

Post Reply