Page 1 of 1

Re: SoftEther Site to Site with Cisco ASA 5520

Posted: Wed Jul 29, 2015 12:02 pm
by SAMbI4
same question....somebody make it?

Re: SoftEther Site to Site with Cisco ASA 5520

Posted: Fri Jul 31, 2015 7:59 am
by SAMbI4
?

Re: SoftEther Site to Site with Cisco ASA 5520

Posted: Mon Aug 03, 2015 8:12 pm
by SAMbI4
up again....

Re: SoftEther Site to Site with Cisco ASA 5520

Posted: Tue Oct 16, 2018 5:53 pm
by sgunnestad
Noone has ever gotten this to work? The article at https://www.softether.org/4-docs/2-howt ... uter_Setup seems lacking, even though the Cisco solution is boasted as the best solution.
AFAIK, the L2TP tunnel should be terminated to a virtual HUB as per the diagram, even if connecting with a L2TP device?
Image

I don't see that there is an IP to assign to the L2TP device/tunnel in the Virtual Layer 3 Switch for the remote site.
Also, I don't see what ethernet device the Local Bridge should connect to for the remote site (Osaka in the diagram)
Any hints would be appreciated.

I have read all of the documentation on this without finding any good solution.

Re: SoftEther Site to Site with Cisco ASA 5520

Posted: Wed Oct 17, 2018 7:21 am
by Fork1337
I'm having the exact same issue as sgunnestad.
Any solution here?

Re: SoftEther Site to Site with Cisco ASA 5520

Posted: Thu Nov 01, 2018 6:40 am
by thisjun
Localbridge can't bridge to a remote site.
Localbridge is for local bridging as its name suggests.

Re: SoftEther Site to Site with Cisco ASA 5520

Posted: Fri Nov 02, 2018 2:44 pm
by sgunnestad
So how is the Cisco unit supposed to authenticate to the L3 Switch?

Is this supposed to work at all? Reading from
https://www.softether.org/4-docs/2-howt ... olution%3F
Image

Why does it not exist any good manual for this? It seems other people who have tried to get this working have given up?
If I get it working I will publish a proper guide.

Regards

Re: SoftEther Site to Site with Cisco ASA 5520

Posted: Thu Nov 15, 2018 8:06 am
by thisjun
Which L3 switch are you asking about?

Re: SoftEther Site to Site with Cisco ASA 5520

Posted: Sat Nov 17, 2018 1:46 pm
by sgunnestad
The Cisco endpoints are authenticating to something at the central site. Doing this with bridge mode works well but I fail to understand how to configure this with routing.

Re: SoftEther Site to Site with Cisco ASA 5520

Posted: Tue Dec 11, 2018 2:07 am
by thisjun
The Virtual L3 switch is just a generic router.
There isn't authentication.
Please just specify IP address of the virtual interface as a gateway.

Re: SoftEther Site to Site with Cisco ASA 5520

Posted: Wed Jan 02, 2019 1:28 pm
by sgunnestad
Could you point me to the relevant documentation for this?

Re: SoftEther Site to Site with Cisco ASA 5520

Posted: Mon Feb 04, 2019 6:25 am
by thisjun
This is manual of virtual L3 switch.
https://www.softether.org/4-docs/1-manu ... 3_Switches