Layer 3 routing between hubs

Post your questions about SoftEther VPN software here. Please answer questions if you can afford.
Post Reply
Posts: 4
Joined: Sat Jan 05, 2019 12:11 pm

Layer 3 routing between hubs

Post by ashah7 » Sat Jan 05, 2019 12:23 pm

Hi All
straightforward scenario but I've spent hours on this without success
I have one server with 2 virtual hubs configured with secureNAT enabled and DHCP set with the below

virtual hub1 -

virtual hub2 -

I want to route between the 2 hubs using the Layer3 switch that I have configured with the below settings for the virtual interface / /

the L3 switch is started and online

From virtual hub1 I can ping all fine
from virtual hub 2 I cannot ping ???

I can see the interfaces created in the IP tables section on both hubs - see attachments

please any advice appreciated - this really seems quite forward without success
You do not have the required permissions to view the files attached to this post.

Posts: 213
Joined: Fri Jul 03, 2015 2:21 pm

Re: Layer 3 routing between hubs

Post by raafat » Thu Jan 10, 2019 3:19 pm

Hello there! Did you notice that you are using overlapping IP settings? Note that "" overlaps with "". But IP routing is involved in routing traffic between different IP subnets. Double check for that issue and try again.

Good luck

Post Reply