Page 1 of 1

Route table

Posted: Fri Jun 07, 2019 3:00 pm
by ricardoc
Hello, I have a question.

I use a VPN client to site to connect to some Internet IPs. I disabled the default route for the VPN but would not like to include the routing on the client, but the VPN already has the required routes registered. You can?

Re: Route table

Posted: Thu Jun 13, 2019 3:28 pm
by ricardoc
Summarizing what I need is to automatically include routes to specific IPs after closing the VPN, that is, today when I close the VPN I have no traffic on it. I need to change the client routing table to forward only the traffic from some IPs to the VPN. I would like to put this update of the routing table in the VPN close stream.

Re: Route table

Posted: Mon Jun 24, 2019 7:40 am
by cedar
What OS do you use on VPN client?