New Standalone VPN Server, no network access

Post your questions about SoftEther VPN software here. Please answer questions if you can afford.
Post Reply
wolvenspirit
Posts: 1
Joined: Fri May 08, 2020 9:21 am

New Standalone VPN Server, no network access

Post by wolvenspirit » Fri May 08, 2020 9:29 am

Hello,

I've been trying to setup the Softether VPN server and finally have achieved some connectivity after setting forwarding rules in router.
I'm connecting with opengw.net host name not though azure and while the connection gets established no traffic is routed through it. And when I check the connection in the control panel it says no network access but connected.

I assume it is a problem with my configuration of the server, I did not setup a bridge because I understood that I don't need it.
I managed to connect to the server through my hotspot from the phone with another win 10 laptop because I wanted them to be from different network to be sure that it works...
Any hints would be appreciated.

Thanks

Stubblemonster
Posts: 2
Joined: Fri May 08, 2020 12:43 pm

Re: New Standalone VPN Server, no network access

Post by Stubblemonster » Fri May 08, 2020 12:52 pm

You need a bridge... Without it the server doesn't know where to route your traffic to!

Post Reply