Page 1 of 1

New Standalone VPN Server, no network access

Posted: Fri May 08, 2020 9:29 am
by wolvenspirit
Hello,

I've been trying to setup the Softether VPN server and finally have achieved some connectivity after setting forwarding rules in router.
I'm connecting with opengw.net host name not though azure and while the connection gets established no traffic is routed through it. And when I check the connection in the control panel it says no network access but connected.

I assume it is a problem with my configuration of the server, I did not setup a bridge because I understood that I don't need it.
I managed to connect to the server through my hotspot from the phone with another win 10 laptop because I wanted them to be from different network to be sure that it works...
Any hints would be appreciated.

Thanks

Re: New Standalone VPN Server, no network access

Posted: Fri May 08, 2020 12:52 pm
by Stubblemonster
You need a bridge... Without it the server doesn't know where to route your traffic to!