OpenVPN -> Softether Server

Post your questions about SoftEther VPN software here. Please answer questions if you can afford.
Post Reply
ikelsinwi
Posts: 1
Joined: Sat Jul 25, 2020 2:59 pm

OpenVPN -> Softether Server

Post by ikelsinwi » Sat Jul 25, 2020 3:01 pm

Dear Community,
I connected a Raspberry Pi via OpenVPN (client) to my Softether Server. It connected but I had only access to Server Network.

But I needed access to Client Network. So if I type hxxp://192.168.0.xxx I will routed to the clients network. There is no collision between my devices and client's network devices. I made it clear that there are no IPs in my Network which are used in the client's network.

Any suggestions?

drkrool
Posts: 93
Joined: Mon May 25, 2020 4:38 am
Location: Quebec, Canada

Re: OpenVPN -> Softether Server

Post by drkrool » Mon Jul 27, 2020 1:34 pm

I beleive you need a 2nd NIC that you would do a localbridge. This nic must be on the client network. In the NIC's configuration on windows/linux, disable all ipv4 settings so that the server isn't in that network itself, just the client that will use that localbridge

Post Reply