Page 1 of 1

Use network subnet

Posted: Thu Sep 10, 2020 3:08 pm
by jcg1
Hello,

I currently have SoftEther working on my network but I need to change the 192.168.30.1 subnet to 192.168.6.1 and make sure all devices use the same IPs as my existing network as some software we use isn't allowing access when users are working remotely on the VPN and the support company told me this could be the reason.

Is there any way to do this with SoftEther? Sorry, my knowledge is very limited so any help you can give me would be much appreciated.

Re: Use network subnet

Posted: Thu Sep 24, 2020 7:44 am
by jcg1
Please can anyone help with this? I'm really struggling to figure this out

Re: Use network subnet

Posted: Fri Sep 25, 2020 9:41 pm
by ethanolson
Your 192.168.6.1 subnet needs to have a DHCP server running, which I assume it does. The DHCP server should share the DNS search domain and DNS servers.

Your VM network needs to allow 'promiscuous' mode if using VMware vSphere. I don't recall if this is doable in Hyper-V.

Disable SecureNAT in your SoftEther Virtual Hub.

Setup a Local Bridge for your hub (it's under Local Bridge Setting on the main panel, not found under Manage Virtual Hub). Select the Hub and the Ethernet adapter and create a local bridge. If you have VLAN tagging, then you have to work with the VLAN Trasparency Setting Tool.

It should work now.

I had to make security changes on the switches to allow multiple MAC addresses for that VM's NIC.