SITE-TO-SITE (LAN to LAN)

Post your questions about SoftEther VPN software here. Please answer questions if you can afford.
Post Reply
majidv2003
Posts: 2
Joined: Sat Sep 19, 2020 12:10 pm

SITE-TO-SITE (LAN to LAN)

Post by majidv2003 » Sun Sep 20, 2020 7:29 am

Dear Teams,

---Scenario---

Branch A(Office)IP: 192.168.1.1
Branch B(Warehouse) 192.168.8.1
----------------------------------------------------
My requirement is that (i have IP telephone and PBX in Office, now i need to add ip telephone in Warehouse too),
So if i make the Office and Warehouse interconnect then i just need to install only ip telephone in warehouse and they can communicate each other.

Need to connect the office and warehouse by LAN TO LAN ,so please anyone explain correctly exact procedure and step by step (if possible screenshot i appreciate)

i tried and with Soft-ether Client and server and its working fine. but for my above scenario i want LAN TO LAN. then only the devices, like DVR, IP telephone, PC can communicate each other.

sky59
Posts: 344
Joined: Tue Sep 11, 2018 5:58 pm

Re: SITE-TO-SITE (LAN to LAN)

Post by sky59 » Sun Sep 20, 2020 8:14 am

You have it already as you write

Now you should switch your mind to networking

I think masks 255.255.240.0 solves your problem

majidv2003
Posts: 2
Joined: Sat Sep 19, 2020 12:10 pm

Re: SITE-TO-SITE (LAN to LAN)

Post by majidv2003 » Sun Sep 20, 2020 12:07 pm

without L3 , is it possible?

L2 cascading connection, what my question is, is it possible by L2?

Okay, Suppose if i do the L2 cascading where should i need to add this 255.255.240.0 subnet , on both end PC where i installed softether

In Office PC i installed softether, config by "Center" and the other Warehouse PC config by "Edge" and established the cascading connection. then i tried to ping one device eg: DVR OR PBX from warehouse and its not working.

Please anyone explain the steps. i appreciate.

iam not core network expert.

Post Reply