Connection fails until tracert is ran

Post your questions about SoftEther VPN software here. Please answer questions if you can afford.
Post Reply
wubuta
Posts: 1
Joined: Fri Apr 19, 2019 7:00 am

Connection fails until tracert is ran

Post by wubuta » Thu Jun 06, 2019 5:54 am

Good day. There is a problem.
From a computer (network router NETIS WF2411E) through a VPN (Softether VPN Client | Remote Access VPN Server https://www.softether.org/@api/deki/fil ... 10-4-1.png) I connect to the remote networks ( TP-LINK TL-WR842ND subnet: 192.168.96.0/255.255.255.0).
Connection passes without problems, but the computer does not see (does not pass the ping) remote server 192.168.96.111.
After running the command

tracert 192.168.96.111

the computer starts to see and ping the remote server. If you restart the router, then you need to run the tracert 192.168.96.111 command again.
There are no restrictions on the local/remote router's firewall. This problem is only on some routers.

Server:
OS: Windows Server 2008 32-bit
SoftEther VPN Server (32-bit) Version 4.29 Build 9680

Client:
OS: Windows 7 32-bit
SoftEther VPN Client (Ver 4.29, Build 9680, rtm)

cedar
Site Admin
Posts: 1202
Joined: Sat Mar 09, 2013 5:37 am

Re: Connection fails until tracert is ran

Post by cedar » Tue Jun 18, 2019 5:57 am

Is an IP address set for the virtual LAN card?
Is routing information set correctly for VPN?
Is the ARP table learned correctly?

Post Reply